nubs cut off ready to measure

Got my lovejoy ! just need to skim it down to size then drill and bore for the the flywheel

I bought a 4 inch hole saw and went to town on the 1 1/4 worth of aluminum I had to cut through. after i got both pieces cut I need to try them out , The best way was right on the warp , tipping a Warp 11 is not an easy trick , back was a little sore the next day . maybe it was from lifting the tranny too

i found this spacer and used it as a temp .

it's very close to the right height . the hole is 4 "
the warp 11 shaft is 1.125 , i'll use approx 3-3.5" hunk of metal to mount the flywheel

SWEET